GE Discovery LS - Figure 6-25: Secondary Base Spreader Bar Clamped into Place; Figure 6-26: Support Casting with Wood

GE HEALTHCARE
DIRECTION 2307224-100, REVISION 6DISCOVERY LS SYSTEM SERVICE MANUAL
Chapter 6 - Table Page 131
3.) Refer to Figure 6-25. Clamp the Side Pieces of the Spreader Bar to the secondary base rails.
(Do not remove any table anchors.)
4.) Tighten the Spreader Bar bolts.
Figure 6-25: Secondary Base Spreader Bar Clamped into Place
5.) Refer to Figure 6-26. Wedge a piece of wood under the clutch motor casting to support it while
removing the nine bolts that fasten it to the secondary base.
Figure 6-26: Support Casting with Wood
6.) If necessary, remove the floor mounted table lateral alignment assembly.