GE Discovery LS - Figure 6-5: Remove the ETC Cover; Figure 6-6: Remove the Middle Support Bar and Bracket

GE HEALTHCARE
DIRECTION 2307224-100, REVISION 6DISCOVERY LS SYSTEM SERVICE MANUAL
Chapter 6 - Table Page 117
6.) Refer to Figure 6-5. Remove the ETC cover.
a.) If necessary, use a flat-blade screwdriver to loosen the two captive thumb screws that
fasten the cover into place.
b.) Set the cover aside.
Figure 6-5: Remove the ETC Cover
7.) Refer to Figure 6-6. Remove the middle support bar and bracket for the ETC Cover.
a.) Use a 1/8 inch Allen wrench to remove the three M4 flat-head screws that fasten the
middle bar into place.
b.) Use a 5 mm Allen wrench to remove the two M6 socket-head screws that fasten the
bracket to ETC chassis.
c.) Follow local guidelines to discard or recycle the bar and bracket.
Figure 6-6: Remove the Middle Support Bar and Bracket
Middle Bar
Bracket on
ETC Chasis