GE Discovery LS - Figure 6-92: Check Relationship between Roller Arm and Pin in the Detent

GE HEALTHCARE
DIRECTION 2307224-100, REVISION 6DISCOVERY LS SYSTEM SERVICE MANUAL
Page 176 Chapter 6 - Table
4.) Refer to Figure 6-92. Push the table into the detent, and check the roller arm. (A gap of at least
0.5 mm should exist between the roller arm and latch pin.
Figure 6-92: Check Relationship between Roller Arm and Pin in the Detent
5.) If the roller arm touches the latch pin when the roller is in the detent:
a.) Move the table away from the detent.
b.) Use a 4 mm Allen wrench to remove the existing M5 detent hardware.
c.) IMPORTANT: Add one shim, and refasten the detent in place with the M5 22 mm
hardware. Add only one shim at a time during this procedure.
d.) Repeat Step 2, Step 3 and Step 4. If the roller arm still rests against the pin, add another
shim and repeat the process.
e.) If the roller arm no longer rests against the latch pin when the roller is in the detent, count
the shims added, and fasten the same number to the remaining detent.
CAUTION It is possible to add too many shims, and destroy the gas spring. Figure 6-92 shows the
maximum acceptable distance between the roller arm and latch pin. Shim for the minimum
clearance between the arm and pin.
Roller arm should not touch latch pin when roller is in the detent.
Roller arm shown at maximum distance.