GE Discovery LS - Figure 6-56: Attach New Ribbon Cable to ETC I;F J4; Figure 6-57: Connect New Cable to J24

GE HEALTHCARE
DIRECTION 2307224-100, REVISION 6DISCOVERY LS SYSTEM SERVICE MANUAL
Chapter 6 - Table Page 153
2.) Refer to Figure 6-56. Attach the ETC I/F J4 side of the Base Drive Enable Cable,
P/N 2340386, to the ETC I/F J4 connector.
Figure 6-56: Attach New Ribbon Cable to ETC I/F J4
3.) Refer to Figure 6-57. Connect the ETC I/F J24 side of the Base Drive Enable Cable to
connector J24.
Figure 6-57: Connect New Cable to J24
Connect new
cable to J4.
Attach to J24