GE HEALTHCARE
DIRECTION 2307224-100, REVISION 6DISCOVERY LS SYSTEM SERVICE MANUAL
Page 162 Chapter 6 - Table
2.) Refer to Figure 6-71. Wrap the belt around the two drive pulleys, and bring the ends together
over the fastener plate.
Figure 6-71: Drive Belt Fastener Plate
3.) Optional: Loosen the idler pulley to release tension on the belt.
a.) Refer to Figure 6-72. Use a 5 mm Allen wrench to remove the top two and bottom left
socket-head cap screws that fasten the drive belt idler pulley to the side rail.
b.) Loosen the lower right screw, but leave it in place.
Figure 6-72: Drive Belt Idler Pulley
Clamp belt into place
over the fastener plate
(shown with clamp
hardware).
Four Socket-Head Cap Screws (Right lower screw left in place.)
Drive Belt Idler Pulley
To Next Page
Loading...
