GE Discovery LS - Page 17

GE HEALTHCARE
DIRECTION 2307224-100, REVISION 6DISCOVERY LS SYSTEM SERVICE MANUAL
Table of Contents Page 17
Chapter 5
Console ................................................................................................................ 107
Section 5.1
CT-PET Console Functional Description ..................................................... 107
Section 5.2
Console Connections .................................................................................... 109
Chapter 6
Table ..................................................................................................................... 111
Section 6.1
CT-PET Table Functional Description.......................................................... 111
6.1.1 Table Overview.............................................................................................................. 111
6.1.2 Manual Table Functional Description ............................................................................ 111
Section 6.2
Manual Table................................................................................................... 112
6.2.1 Prerequisites.................................................................................................................. 112
6.2.1.1 )Furnished Materials ...................................................................................... 112
6.2.1.2 Required Tools............................................................................................... 112
6.2.2 Before Beginning ........................................................................................................... 113
6.2.3 Pre-Mechanical Installation............................................................................................ 113
6.2.4 Mechanical Installation .................................................................................................. 114
6.2.4.1 Remove the Table Covers ............................................................................. 114
6.2.4.2 Remove the Base Cover Brackets ................................................................. 118
6.2.4.3 Install the Mechanical Stop Assembly............................................................ 121
6.2.5 Remove the Manual Control Hardware ......................................................................... 122
6.2.5.1 Remove the KB Box....................................................................................... 122
6.2.5.2 Unfasten and Remove the Cables ................................................................. 123
6.2.5.3 Unfasten and Remove the KB Box ................................................................ 123
6.2.5.4 Remove the Pedal Assembly ......................................................................... 124
6.2.5.5 Remove the PET and CT Position Switches and Switch Rail ........................ 124
6.2.5.6 Remove the Switch Rail ................................................................................. 125
6.2.5.7 Disconnect and Discard the CT-PET Positions Cable (P/N 2318721)........... 126
6.2.5.8 Remove the Cable Harness (P/N 2271256) from the Table .......................... 127
6.2.5.9 Remove the INTF SW and CL CONT I Cable (P/N 2309066) from the Table 128
6.2.5.10 Remove the Motor Clutch Assembly (P/N 2309067) ..................................... 129
6.2.5.11 Assemble and Attach the Spreader Bar Assembly ........................................ 130
6.2.6 Install the Automated Base Hardware ........................................................................... 132
6.2.6.1 Drill and Tap the Right Secondary Base Rail................................................. 132
6.2.6.2 Determine the Right Secondary Base Rail Revision...................................... 133
6.2.6.3 Attach the CT Template and Drill the Hole(s) ................................................ 134
6.2.6.4 Determine the PET Detent Location .............................................................. 136
6.2.6.5 Attach the PET Template and Drill the Standard PET Detent Holes ............. 137
6.2.6.6 Fasten PET Detent Offset Template (P/N 2371258) to Revision 3 Rail......... 139
6.2.6.7 Fasten the PET Detent Offset Template to the Revision 0, 1 or 2 Rail.......... 140
6.2.6.8 Drill a New Set of PET Detent Holes 10mm Closer to the CT Detent............ 141
6.2.6.9 Drill a New Set of PET Detent Holes 20 mm Closer to the CT Detent........... 141
6.2.6.10 Install the New Clutch Motor Assembly.......................................................... 142