Huawei Quidway S9300

100.13.1.1/32 Direct 0 0 D 127.0.0.1 InLoopBack0
100.13.1.2/32 Direct 0 0 D 100.13.1.2 Vlanif20
100.34.1.0/30 OSPF 10 2 D 100.13.1.2 Vlanif20
127.0.0.0/8 Direct 0 0 D 127.0.0.1 InLoopBack0
127.0.0.1/32 Direct 0 0 D 127.0.0.1 InLoopBack0
Step 3 Configure the basic MPLS capabilities on the MPLS backbone network.
# Enable MPLS, and set LSR-ID as the IP address of the Loopback1 interface. Enable MPLS
on the interfaces of the backbone network.
# Configure PE1.
[PE1] mpls lsr-id 1.1.1.1
[PE1] mpls
[PE1-mpls] quit
[PE1] interface vlanif 20
[PE1-Vlanif20] mpls
[PE1-Vlanif20] quit
[PE1] interface vlanif 40
[PE1-Vlanif40] mpls
[PE1-Vlanif40] quit
# Configure the P.
[P] mpls lsr-id 4.4.4.4
[P] mpls
[P-mpls] quit
[P] interface vlanif 20
[P-Vlanif20] mpls
[P-Vlanif20] quit
[P] interface vlanif 30
[P-Vlanif30] mpls
[P-Vlanif30] quit
# Configure PE2.
[PE2] mpls lsr-id 2.2.2.2
[PE2] mpls
[PE2-mpls] quit
[PE2] interface vlanif 40
[PE2-Vlanif40] mpls
[PE2-Vlanif40] quit
# Configure PE3.
[PE3] mpls lsr-id 3.3.3.3
[PE3] mpls
[PE3-mpls] quit
[PE3] interface vlanif 30
[PE3-Vlanif30] mpls
[PE3-Vlanif30] quit
Step 4 Set up an MPLS TE tunnel between PE1 and PE3, and an LSP between PE1 and PE2.
# Configure PE1.
[PE1] mpls
[PE1-mpls] mpls te
[PE1-mpls] mpls rsvp-te
[PE1-mpls] mpls te cspf
[PE1-mpls] quit
[PE1] interface vlanif 20
[PE1-Vlanif20] mpls te
[PE1-Vlanif20] mpls rsvp-te
[PE1-Vlanif20] mpls te max-link-bandwidth 50
[PE1-Vlanif20] mpls te max-reservable-bandwidth 30
[PE1-Vlanif20] quit
[PE1] mpls ldp
5 PWE3 Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
5-78 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)