Intel D50DNP Series - Page 12

Intel® Server D50DNP Family Integration and Service Guide
12
List of Figures
Figure 1. System Directional Reference ........................................................................................................................................... 24
Figure 2. Removing the Air Duct (Half-width Modules) ............................................................................................................. 25
Figure 3. Installing the Air Duct (Half-width Modules) ............................................................................................................... 25
Figure 4. Removing the Air Duct (D50DNP2MFALAC Module) ............................................................................................... 26
Figure 5. Installing the Air Duct (D50DNP2MFALAC Module) ................................................................................................ 26
Figure 6. 1U Supported Standard Processor Heat Sinks ......................................................................................................... 27
Figure 7. 1U Supported EVAC Processor Heat Sinks ................................................................................................................. 27
Figure 8. 2U Heat Sinks ........................................................................................................................................................................... 28
Figure 9. 1U Heat Sinks Installed in Module .................................................................................................................................. 28
Figure 10. Supported Processor Carrier Clips ............................................................................................................................... 29
Figure 11. Processor Components and Processor Socket Reference Diagram with Standard Heat Sink ........... 30
Figure 12. Installing the Processor Carrier Clip onto the Processor – Part 1 ................................................................... 31
Figure 13. Installing the Processor Carrier Clip onto the Processor – Part 2 ................................................................... 31
Figure 14. Heat Sink Handling ............................................................................................................................................................. 32
Figure 15. Processor Heat Sink Anti-tilt Wires in the Outward Position ............................................................................ 32
Figure 16. Aligning Pin 1 Indicator ..................................................................................................................................................... 33
Figure 17. Socket Protective Cover Removal ................................................................................................................................ 33
Figure 18. PHM Alignment with the Socket Assembly .............................................................................................................. 34
Figure 19. PHM Installation onto the Server Board .................................................................................................................... 34
Figure 20. Tighten Heat Sink Fasteners ........................................................................................................................................... 35
Figure 21. Processor Components and Processor Socket Reference Diagram with EVAC Heat Sink ................... 36
Figure 22. Installing the Processor Carrier Clip onto the Processor – Part 1 ................................................................... 37
Figure 23. Installing the Processor Carrier Clip onto the Processor – Part 2 ................................................................... 37
Figure 24. Handling Heat Sink ............................................................................................................................................................. 38
Figure 25. Processor Heat Sink Anti-tilt Wires in the Outward Position ............................................................................ 38
Figure 26. Pin 1 Indicator Alignment ................................................................................................................................................ 39
Figure 27. Removing a Riser Assembly ............................................................................................................................................ 39
Figure 28. Socket Protective Cover Removal ................................................................................................................................ 40
Figure 29. PHM Alignment with the Socket Assembly .............................................................................................................. 40
Figure 30. PHM Installation onto the Server Board .................................................................................................................... 41
Figure 31. Tighten EVAC Heat Sink Extension .............................................................................................................................. 41
Figure 32.Installing a Riser Assembly ............................................................................................................................................... 42
Figure 33. Installing the Processor Carrier Clip onto the Processor – Part 1 ................................................................... 43
Figure 34. Installing the Processor Carrier Clip onto the Processor – Part 2 ................................................................... 43
Figure 35. Socket Protective Cover Removal ................................................................................................................................ 44
Figure 36. Align Processors and Processor Carrier Clips with Sockets .............................................................................. 44
Figure 37. Screws to be removed before the installation ........................................................................................................ 45
Figure 38. Liquid-Cooling Loop Components ............................................................................................................................... 46
Figure 39. Assembling the Manual Applicator .............................................................................................................................. 46