Lexmark Optra W810 - Diagnostic Aids; Operator Menu Disabled; Diagnostics Mode; Diagnostics Mode Menu Structure

Diagnostic Aids 3-1
4023-001
3. Diagnostic Aids
Operator Menu Disabled
If the operator has disabled the menu and you want to run operator
print tests, turn the machine off, and then press Go and Stop as you
turn the machine on.
Diagnostics Mode
To run the printer diagnostic tests, you must put the printer in
Diagnostics mode. The controller card must be plugged into the
system board (normal state).
To enter Diagnostics mode:
1. Turn the printer off.
2. Press and hold the Go and Return buttons as you turn on the
machine. The printer performs the Power-On Self Test.
3. Release the buttons when [Performing Self Test] displays.
4. Select [Reset Printer] to exit Diagnostics mode without a POR.
5. Press EXIT DIAGNOSTICS to exit Diagnostics mode and POR
the printer.
Diagnostics Mode Menu Structure
The following is the Diagnostics mode menu structure, The indented
items are sub-menus available under the main menu items, which
are in capital letters on the operator panel. Menu items referring to
options are only present if those options are installed. Menus with
more than four items use [MORE] on the fourth operator panel
button to access the next screen of selections.
PRINT TESTS
Tray 1
Tray 2
Tray 3
Tray 4
Prt Quality Pgs