3-14 Service Manual
4023-001
Feed To All Bins Test
The Feed To All Bins operation within the output bin tests menu
verifies that media can be fed to all the output destinations on the
finisher as well as the printer standard bin. After this test is selected,
media is fed from the user default paper source. The first piece of
media is fed to Bin 1. A second piece is fed to Bin 2, and so on until
the last bin is reached. Then the sequence is repeated in reverse.
This cycle is repeated continuously until you stop the test.
Note: No information is printed on the test pages since the laser
isn’t engaged during the test. Some output bins cannot accept all
paper sizes. If the printer’s user default paper source has
unsupported media installed, the printer automatically diverts all
output to Bin 1. No warning or message is posted when media is
diverted.
1. Enter the Diagnostic mode. See “Diagnostics Mode” on
page 3-1.
2. Select [OUTPUT BIN TESTS].
3. Select [Feed To All Bins].
– The following message displays and the power indicator
blinks:
All Bin Test
Feeding...
4. Press Return or Stop to stop the test.
– The following message displays:
All Bin Testing
Cancelling...
5. Press Return to go back to Diagnostics mode main menu.
Finisher Tests
Staple Test
Note: No information is printed on the test pages that are stapled
since the laser isn’t engaged during the test. The finisher cannot
accept all paper sizes and types. If the printer’s user default paper
source has unsupported media installed, the printer automatically
diverts all output to Bin 1 on either the mailbox or the finisher and no
stapling occurs. No warning or message is posted when media is
diverted. The staple test cannot be cancelled or terminated when
To Next Page
Loading...
