Diagnostic Aids 3-5
4023-001
<input source>
Printing...
Note: <input source> represents the input source selected for
the print test. One of the following sources displays: Tray 1,
Tray 2, Tray 3, Tray 4, Tray 5, or MP Feeder.
5. Press Return or Stop to stop continuous print.
6. Press Return to go back to Diagnostics mode main menu.
Note: The print test page is a single page regardless of the duplex
setting or the presence of the duplex unit.
Print Quality Pages
1. Enter the Diagnostic mode. See “Diagnostics Mode” on
page 3-1.
2. Select [PRINT TESTS].
3. Select [Prt Quality Pgs].
– The following message displays while printing:
Prt Quality Pgs
Printing...
4. Press Return to go back to Diagnostics mode main menu.
Hardware Tests
LCD Hardware Test
1. Enter the Diagnostic mode. See “Diagnostics Mode” on
page 3-1.
2. Select [HARDWARE TESTS].
3. Select [LCD Test].
– The LCD test continually executes the LCD display test.
4. Press Return/Stop to cancel the test.
To Next Page
Loading...
