Diagnostic Aids 3-21
4023-001
Flash Test
This test causes the file system to write and read data on the flash to
test the flash.
WARNING: This test destroys all data on the flash because the
flash is reformatted at the end of the test.
1. Enter the Diagnostic mode. See “Diagnostics Mode” on
page 3-1.
2. Select [DEVICE TESTS].
3. Select [Flash Test].
– The power indicator blinks while the test is running.
– “Flash Test/Test Passed” message displays if the test
passes and the power indicator turns on solid.
– “Flash Test/Test Failed” message displays if the test fails and
the power indicator turns on solid.
4. Press Go, Return, or Stop to return to the Device Tests menu.
Printer Setup
Setting the Page Count
1. Enter the Diagnostic mode. See “Diagnostics Mode” on
page 3-1.
2. Select [PRINTER SETUP].
3. Select [Page Count].
– The following message displays:
– Page Count
=1234567*
– The left-most digit (‘1’ in this example) blinks, indicating it is
the first digit to be changed.
4. Press Menu> or Menu< until the value you want displays.
5. Press Select to move to the next digit.
6. After entering the page count, move to after the final digit and
press Select.
To Next Page
Loading...
