1-58 Service Manual
4023-001
Both lift 1 and 2 perform the following sequence of operations to
maintain pressure between the paper and paper take-up roll.
1. Lift 1 and 2 ascends.
• LCC is slid into position.
• The lift-up sensor is unblocked while a paper take-up
sequence occurs with paper present on the lift.
2. Lift 1 and 2 stops.
• Lift-up sensor is blocked.
• The paper stack top level position is being corrected.
3. LCC lift-up motor EMOT energizes.
4. Lift 1 and 2 descends.
• LCC is slid out of the printer.
• Lift 1 and 2 are lowered.
Note: To absorb shocks that would otherwise be applied during
the descent motion, springs are loaded in the rear side of the
LCC.
To Next Page
Loading...
