Chapter 5 Memory and Parameter
2. I/O Parameter
(1) Built-in input/output setting
(a) Input filter function
The built-in input part of the motion controller has an input filter function to prevent the external noise signal flowing into the
input signal. In environments where there is a lot of noise or in the case of the equipment where the pulse width of the input
signal acts as an important factor, the system may be subjected to incorrect input depending on the state of the input signal. In
order to prevent such mistaken input, the input filter function does not accept the signal that is shorter than the time set by the
user as input.
The input filter time can be set 1ms~100ms.
To Next Page
Loading...
