Chapter 6 Motion Function Blocks
parameters
feed setting
continuous blocks for
acceleration / deceleration
before interpolation
When executing the consecutive blocks, it creates
the connecting trajectory that draws an arc on the
corner of the connecting trajectory with the speed set
with the next block. 1: When it is set to Buffered, the
circular arc is not inserted.
1: Buffered
2: Blending Low
3: Blending Previous
4: Blending Next
9 Acceleration at the time of
cutting feed (before
Acceleration at the time of cutting feed
Deceleration at the time of
cutting feed (before
Deceleration at the time of cutting feed
Jerk at the time of cutting
feed (before interpolation)
Jerk at the time of cutting feed
8.Tool
diameter
compensation
129 How to apply the
compensation value of the
tool diameter
Set the method of applying the compensation
amount of the tool diameter when compensating the
tool diameter.
0: Apply the diameter value
1: Apply the radius value
130 Compensation type of the
tool diameter
Tool diameter Sets the type of traversing method at
the beginning and end of the calibration.
0: Type 1(Bypass traverse)
1: Type 2(Direct traverse)
Whether to check the tool
interference during tool
diameter compensation
Set whether to check the tool interference during tool
diameter compensation
0: Do not check
Compensation amount of
the tool diameter 1
Compensation amount 1 to be used to compensate
the tool diameter
Compensation amount of
the tool diameter 128
Compensation amount 128 to be used to
compensate the tool diameter
To Next Page
Loading...
