LSIS XGT Series - Page 844

Appendix 2 Error Information & Solution
A2-10
Error code
Error Description Solutions
Hex
Dec
104E
4174
The setting value of jog deceleration exceeded
the range.
Set the parameter setting value to more than 0.
104F
4175
The setting value of jog jerk exceeded the range.
Set the parameter setting value to more than 0.
1050
4176
Motor-side gear ratio setting value exceeded the
range.
Set the parameter setting value to 1 ~ 65535.
1051
4177
Machine-side gear ratio setting value exceeded
the range.
Set the parameter setting value to 1 ~ 65535.
1052 4178 The setting value for the number of pulses per
rotation exceeded the range.
Set the parameter setting value to be greater than 0 and less
than or equal to 4294967295.
1053 4179 Connection device setting value exceeded the
range.
Set the device number of the slave that can be supported. The
node setting range is 0(no connection device), and 1 ~ 64.
1054 4180 Axis type setting value exceeded the range. Set the parameter setting value to '0: actual axis' or '1: virtual
axis'.
1055 4181 Speed command unit setting value exceeded the
range.
Set the parameter setting value from '0: unit/sec', '1: unit/min', '2:
rpm'.
1060
4192
Servo On cannot be executed due to occurrence
of servo drive errors.
Execute Servo On after checking the error factor of the servo
drive and removing the servo drive error.
1061
4193
Servo On command was executed again in the
middle of processing Servo On.
Check whether the Servo On command was performed again in
the middle of processing Servo On in program or XG5000.
1062
4194
It is not possible to complete Servo On because
the servo drive cannot be changed to
"ReadyToSwitchON" state.
Check the status of the servo drive. The Servo On command
may not be executed in certain circumstances.
1063 4195 It is not possible to complete Servo On because
the servo drive cannot be changed to "Switched
on" stage.
Check the status of the servo drive. The Servo On command
may not be executed in certain circumstances.
1064
4196
It is not possible to complete Servo On because
the servo drive cannot be changed to "Operation
enabled" state.
Check the status of the servo drive. The Servo On command
may not be executed in certain circumstances.
1065
4197
It is not possible to complete Servo On because
"Quick Stop" of servo drive is enabled.
Check the status of the servo drive. The Servo On command
may not be executed in certain circumstances.
1066
4198
Servo Off command was executed again in the
middle of processing Servo Off.
Check whether the Servo Off command was performed again in
the middle of processing Servo Off in program or XG5000.
1067 4199 The execution of Servo Off command was not
completed.
Check the status of the servo drive.
1070 4208 It exceeded the servo error reset monitoring time. The servo drive error has not been cleared even after the error
reset monitoring time set in the axis parameter went by. Execute
the error reset command again after removing the servo drive
error factor.
1080
4224
Commands that use absolute coordinates cannot
be executed at absolute coordinates of the state
of undetermined origin.
Execute the absolute coordinate operation command after
making the determined origin state with homing command or
current position setting command.
1081 4225 In infinite length repeat enable state, the target
position was beyond the range of infinite length
repeat position from the direction specification.
Set the target position within the infinite length repeat position
from the direction specification.