MacDon D1 Series - Page 15

Section
Summary of Change
Internal Use
Only
• Clear the area of other persons, pets etc. Keep children away
from machinery. Walk around the machine to be sure no one
is under, on, or close to it.
Calibrating the Auto Header
Height Control – Challenger and
Massey Ferguson, page 360
Added WARNING:
• Clear the area of other persons, pets etc. Keep children away
from machinery. Walk around the machine to be sure no one
is under, on, or close to it.
Tech Pubs
Adjusting the Header Height –
Challenger and Massey Ferguson,
page 363
Added WARNING:
• Clear the area of other persons, pets etc. Keep children away
from machinery. Walk around the machine to be sure no one
is under, on, or close to it.
Tech Pubs
Setting the Sensitivity of the Auto
Header Height Control –
Challenger and Massey Ferguson,
page 365
Added WARNING:
• Clear the area of other persons, pets etc. Keep children away
from machinery. Walk around the machine to be sure no one
is under, on, or close to it.
Tech Pubs
Setting the Sensitivity of the Auto
Header Height Control – CLAAS
500 Series, page 370
• Figure 9.147, page 371
Cleaned picture. Tech Pubs
Calibrating Reel Height Sensor –
CLAAS 600 and 700 Series, page
380
• Step 1, page 380
Added IMPORTANT:
• Do NOT turn off the engine. The combine has to be at full idle
for the sensors to calibrate properly.
Engineering
9.1.11 CLAAS 8000/7000 Series
Combines, page 383
Added CLAAS 8000/7000 Series topics.
Tech Pubs
Calibrating Reel Height Sensor –
John Deere S and T Series, page
447
• Step 1, page 447
Added IMPORTANT:
• Do NOT turn off the engine. The combine has to be at full idle
for the sensors to calibrate properly.
Engineering
Calibrating Header – John Deere
S7 Series, page 459
Added WARNING:
• Never start or move the machine until you are sure all
bystanders have cleared the area.
Tech Pubs
Calibrating Header – John Deere
S7 Series, page 459
Reworded introduction to specify that the center-link should be
set to “D” instead of the “steepest angle.”
Tech Pubs
9.1.18 New Holland Combines –
CR/CX Series – 2014 and Prior,
page 462
Corrected model year range in topic title:
• Now “2014 and Prior”, was “2015 and Prior.”
Tech Pubs
Setting Preset Cutting Height –
New Holland CR/CX Series, page
471
• Step 5, page 471
Added steps. Tech Pubs
215184 xiii Revision A