12.7 H: TERMINALS
616 SIEPCYEUOQ2V01A Q2V Technical Manual
■ B: Rev Trq Lim
Setting Value Function Description
B Rev Trq Lim
Enters the load torque limit if the motor rated torque is 100%.
Note:
When you use L7-01 to L7-04 and analog inputs to set torque limits for the same quadrant, it will enable the lower torque limit.
■ C: RegenTrqLim
Setting Value Function Description
C RegenTrqLim
Enters the regenerative torque limit if the motor rated torque is 100%.
Note:
When you use L7-01 to L7-04 and analog inputs to set torque limits for the same quadrant, it will enable the lower torque limit.
■ D: GenerTrqLim
Setting Value Function Description
D GenerTrqLim
Enters the torque limit that is the same for all quadrants for forward, reverse, and regenerative operation if the motor rated
torque is 100%.
■ E: OvUntrq Level
Setting Value Function Description
E OvUntrq Level
Enters a signal to adjust the overtorque/undertorque detection level.
When A1-02 = 0, 5 [Control Method = V/f Control, PM OLVector], the drive rated current is 100%. When A1-02
= 2, 6, 8 [OLVector, PM AOLVector, or EZ Vector], the motor rated current is 100%.
Note:
Use this function with L6-01 [Trq Det1 Select]. This parameter functions as an alternative to L6-02 [Trq Det1 Level].
■ F: PID Fbk
Setting Value Function Description
F PID Fbk
Enter the PID feedback value as a percentage of the maximum output frequency.
When you use this function, set b5-01 = 1 [PID Enable = Enabled].
■ 10: PID SetPoint
Setting Value Function Description
10 PID SetPoint
Enters the PID setpoint as a percentage of the maximum output frequency.
When you use this function, set b5-01 = 1 [PID Enable = Enabled].
Note:
Configuring this function disables the frequency reference set with b1-01 [Freq. Ref. Sel. 1].
■ 11: Diff PIDFbk
Setting Value Function Description
11 Diff PIDFbk
Enters the PID differential feedback value if the full scale analog signal (10 Vor 20 mA) is 100%.
The drive uses the deviation between the PID feedback and the differential feedback value signals to calculate the
PID input.
To Next Page
Loading...
Need help?
General