Configuring Storage Area Network (SAN)
TABLE 27
NDMP Status - Recent Activity
Field Description Examples
ID NDMP backup ID 49
Active Backup currently active No
Remote Client NDMP client address and port 192.168.1.219:4760
Authenticated Shows if the client has completed
authentication yet
Yes, No
Data State See Data State Active, Idle, ...
Mover State See Mover State Active, Idle, ...
Current Operation Current NDMP operation Backup, Restore, None
Progress A progress bar for this backup
NDMP States
The NDMP Data State shows the state of the backup or restore operation. Possible values are:
■
Active - The data is being backed up or restored.
■
Idle - Backup or restore has not yet started or has already finished.
■
Connected - Connection is established, but backup or restore has not yet begun.
■
Halted - Backup or restore has finished successfully or has failed or aborted.
■
Listen - Operation is waiting to receive a remote connection.
The NDMP Mover State shows shows the state of the NDMP device subsystem. Examples for
tape devices are:
■
Active - Data is being read from or written to the tape.
■
Idle - Tape operation has not yet started or has already finished.
■
Paused - Tape has reached the end or is waiting to be changed.
■
Halted - Read/write operation has finished successfully or has failed or aborted.
■
Listen - Operation is waiting to receive a remote connection.
Configuring Storage Area Network (SAN)
The SAN configuration page lets you connect your appliance to your Storage Area Network
(SAN). A SAN is made up of three basic components:
■
A client that will access the storage on the network
128 Oracle ZFS Storage Appliance Administration Guide, Release OS8.6.x • September 2016
To Next Page
Loading...
Need help?
General
