Oracle ZFS Storage Appliance

Canceling a Replication Update (CLI)
■
“Manually Sending a Replication Update (BUI)” on page 481
Canceling a Replication Update (CLI)
You can cancel in-progess replication updates on the target. Replication packages are organized
in the CLI by source under shares replication sources.
1.
From the target appliance, navigate to the replication package.
loader:> shares replication sources
loader:shares replication sources> show
Sources:
source-000 ayu
PROJECT STATE LAST UPDATE
package-000 oldproj idle unknown
package-001 aproj1 receiving Sun Feb 21 2010 22:04:35 GMT+0000 (UTC)
2.
First select a source, then select a package.
loader:shares replication sources> select source-000
loader:shares replication source-000> select package-001
3.
Enter cancelupdate.
loader:shares replication source-000 package-001> cancelupdate
It might take several seconds for the cancellation to complete.
Note - A manual update cannot be initiated from the target appliance. You must log into the
source appliance to initiate a manual update.
Related Topics
■
“Replication Packages” on page 550
■
“Manually Sending a Replication Update (CLI)” on page 481
Cloning a Replication Package (BUI)
A clone of a replication package is based on the most recently received replication snapshot.
Remote Replication 505