Oracle ZFS Storage Appliance

Shutting Down a Clustered Configuration (BUI)
10.
Go to Configuration > Cluster and click FAILBACK to bring the cluster to Active:
Active mode.
The two controllers are now configured as clustered peers.
11.
On the second controller, go to Configuration > Cluster and click the lock icon
for the management interface.
Related Topics
■
“Clustering Considerations for Storage” on page 212
■
“Cluster Configuration BUI View” on page 193
Shutting Down a Clustered Configuration (BUI)
Use this procedure to shut down a clustered configuration.
1.
From one of the peer controllers, go to Configuration > Cluster.
2.
Determine the state of both controllers.
In the following figure, the active controller is controller-a, and the standby controller is
controller-b.
Use the following table to determine the state of each controller.
controller-a controller-b Condition
Active Active
Both controllers are running in a
normal clustered condition.
Configuring the Appliance 197