Adding an Alert Action (CLI)
Executing a Workflow
Workflows can be optionally executed as alert actions. To let workflow be eligible as an alert
action, its alert action must be set to true. For more information about executing a workflow,
see “Maintenance Workflows” on page 587.
Threshold Alerts
These are alerts based on the statistics from Analytics. The following are properties when
creating threshold alerts:
TABLE 41
Threshold Alert Properties
Property Description
Threshold The threshold statistic is from Analytics, and is self
descriptive (eg, "Protocol: NFSv4 operations per
second")
exceeds/falls below defines how the threshold value is compared to the
current statistic
Timing: for at least Duration which the current statistic value must exceed/
fall below the threshold
only between/only during These properties may be set so that the threshold is only
sent during certain times of day - such as business hours
Repost alert every ... this condition persists. If enabled, this will re-execute the alert action (such as
sending email) every set interval while the threshold
breech exists
Also post alert when this condition clears for at least ... Send a followup alert if the threshold breech clears for at
least the set interval
The "Add Threshold Alert" dialog has been organized so that it can be read as though it is a
paragraph describing the alert. The default reads:
Threshold CPU: percent utilization exceeds 95 percent.
Timing for at least 5 minutes only between 0:00 and 0:00 only during weekdays.
Repost alert every 5 minutes while this condition persists.
Also post alert when this condition clears for at least 5 minutes.
Related Topics
■
“Configuring a Threshold Alert (BUI)” in Oracle ZFS Storage Appliance Analytics Guide,
Release OS8.6.x
Configuring the Appliance 191
To Next Page
Loading...
Need help?
General
