Orolia SecureSync 2400 - Page 416

The Edit window allows the configuration of the following settings:
Signature Control: Used to control when the IRIG modulation will be present. This
function allows the modulation to stop under certain conditions;see also "Signature
Control" on page161.
Format: Used to configure the desired IRIG output formatting. The available
choices are:
IRIG A
IRIG B
IRIG G
IRIG E
NASA-36
Modulation: Changes the type of output signal modulation. The available choices
are:
IRIG DCLS: TTL-modulated output
IRIG AM: Amplitude-modulated output. The amplitude of the output is
determined by the value entered in the Amplitude field.
Frequency: The IRIG modulation frequency. This is determined by the configuration
of Format and Modulation Type. See "IRIG Carrier Frequencies" on page546 for
details.
400 SecureSync 2400 User Manual
APPENDIX