6.
Proceed with the SW configuration of the STL settings, as described below.
Note: The RJ-45 MAINT. connector will not be needed for the STL
configuration. Use this connector only if so requested by Spectracom
Service personnel.
Configuring STL Settings
Note: If you do not yet have a subscription key, you will need to obtain one
before continuing with installation. Please contact Orolia customer service:
stlsubscription@orolia.com
US: +1 585 321 5800; France: +33 (0)1 64 53 3980
Note: During the initial installation of a unit equipped with an STL card, the
exact geographic position needs to be entered into the Web UI (see
below). Should the unit be relocated at a later point in time, the position
must be changed accordingly.
The STL option card 1204- 3E is configured via the SecureSync WebUI. See "The
SecureSync Web UI" on page30 for basic SecureSync setup and initial login information.
SecureSync 2400 User Manual 481
APPENDIX
To Next Page
Loading...
