27 August 2019
BM3050 iv Cover
Safety Information
When using this machine, following safety precautions should always be followed.
Safety during operation
WARNING:
• To avoid hazardous situations such as electric shock or danger while exposed to moving, rotating or cutting devices, do not remove any
covers, guards or screws other than those specied in this manual.
• Turn off the power and disconnect the power plug (by pulling the plug, not the cable) if any of the following conditions exist:
• Before disassembling or assembling parts of the System and peripherals.
• You drop objects or spill something into the equipment.
• You suspect that your equipment needs service or repair.
• Machine covers have been damaged
• You notice unusual noises or odours when operating the equipment.
• If the power cable or plug becomes worn out or otherwise damaged.
• Before cleaning and care (unless otherwise specically instructed).
• If any adjustment or operation check has to be made with exterior covers off or open while the main switch is turned on, keep hand away
from electrical or mechanically driven components.
• Note that components of the System and peripherals can be supplied with electric voltage even if the main power switch is turned off
and the power cord is disconnected.
• Electromagnetic compliance:
• This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be re-
quired to take adequate measures.
• The product (System) which is connected to this machine will be class A.
To Next Page
Loading...
