PREVOST X3-45 COMMUTER User Manual

SECTION 18: BODY
72
DOB 1300-1556 | X3-45 Commuter PA-1648 Maintenance Manual First release Oct 2020
FIGURE 142: FENDER MOUNTING FASTENERS
5. Unplug entrance door switch and lights.
6. Remove rub rails, entrance door switch and
lights on the fender.
FIGURE 143: COMPONENTS INSTALLED ON FENDER
FRONT FENDER INSTALLATION
7. Remove glue and clean all mounting faces
on the vehicle.
8. Install rub rails, entrance door switch and
lights on the new fender.
9. Apply glue Simsons 70-03 (685126) on the
fender mounting faces as shown in Figure
144.
FIGURE 144: GLUE APPLICATION
10. Plug entrance door switch connector and
light connectors.
11. Install the fender on the vehicle and position
at 6mm from the compartment door.
FIGURE 145: FENDER POSITIONNING
12. Install rivets and screws.
13. Fill the cavity with sealant Sika 252
(#683083).

PREVOST X3-45 COMMUTER Specifications

General

Engine	Volvo D13
Transmission	Allison B500
Fuel Type	Diesel
Length	45 ft (13.7 m)
Width	102 in (2.6 m)
Horsepower	500 hp
GVWR	54, 000 lbs
Height	141 in