R&S SMA100B - Page 169

Avionic standards
R&S
®
SMA100B
169User Manual 1178.3834.02 ─ 09
If no coding is set, the COM/ID tone is sent uncoded (key down).
Remote command:
[:SOURce<hw>]:ADF:COMid:CODE on page 600
Period
Sets the period of the COM/ID signal.
Remote command:
[:SOURce<hw>]:ADF:COMid:PERiod on page 602
Frequency
Sets the frequency of the COM/ID signal.
Remote command:
[:SOURce<hw>]:ADF:COMid:FREQuency on page 601
Depth
Sets the AM modulation depth of the COM/ID signal.
Remote command:
[:SOURce<hw>]:ADF:COMid:DEPTh on page 601
Time Schema
Sets the time schema of the Morse code for the COM/ID signal.
"Standard"
The set dot length determines the length of the dash, the symbol
space and letter space of the Morse code.
"User"
You can set each length value separately.
Remote command:
[:SOURce<hw>]:ADF:COMid:TSCHema on page 602
Dot Length
Sets the length of a Morse code dot.
If "Time Schema > Standard", the dot length value determines also the length of the
dash (= 3 times the dot length), symbol space (= dot length) and letter space (= 3 times
the dot length).
Remote command:
[:SOURce<hw>]:ADF:COMid:DOT on page 601
Dash Length
Requires "Time Schema > User".
Sets the length of a Morse code dash.
Remote command:
[:SOURce<hw>]:ADF:COMid:DASH on page 600
Symbol Space
Requires "Time Schema > User".
Sets the length of the Morse code symbol space.
ADF configuration and settings