R&S SMA100B - Page 408

Network operation and remote control
R&S
®
SMA100B
408User Manual 1178.3834.02 ─ 09
The LXI "LAN Status" dialog shows the parameters of the LAN connection.
Alternatively, you can change the LAN settings using the LXI web browser interface,
see Chapter 13.6.2.1, "LAN configuration", on page 410.
LAN Status
The LED indicates the LXI status.
"green"
Normal operation
"green (flashing)"
Device identification
"red"
LAN fault
Hostname / MAC Address / IP Address
See "Hostname" on page 398.
LAN Reset
Initiates the network configuration reset mechanism for the instrument and resets the
hostname, MAC address, and IP address.
According to the LXI standard, a LAN reset must set the following network parameters
to a default state:
Parameter Value
TCP/IP mode DHCP + Auto IP address
Dynamic DNS Enabled
ICMP ping Enabled
Password for LAN configuration LxiWebIfc
The LAN reset also resets the following parameters for the Signal Generator:
LXI settings