R&S SMA100B - Page 527

Remote control commands
R&S
®
SMA100B
527User Manual 1178.3834.02 ─ 09
Parameters:
<Steps> integer
Range: 10 to 1000
*RST: 500
Example:
SENS:SWE:POW:STEP 500
Sets the 500 measurement steps.
Manual operation: See "Steps - Power Analysis" on page 257
:SENSe[:POWer]:SWEep:POWer:STOP
<Stop>
Sets the stop level for the power versus power measurement.
Parameters:
<Stop> float
Range: -145 to 20
Increment: 0.01
*RST: 40
Example:
SENS:SWE:POW:STOP 20.0DBM
Sets the stop level to 20 dBm.
:SENSe[:POWer]:SWEep:POWer:TIMing[:MODE] <Mode>
Selects the timing mode of the measurement.
Parameters:
<Mode> FAST | NORMal | HPRecision | FAST | NORMal
FAST
Selection FAST leads to a fast measurement with a short inte-
gration times for each measurement step.
NORMal
NORMal leads to a longer but more precise measurement due
to a higher integration time for each step.
*RST: NORMal
Example:
SENS:SWE:POW:TIM:MODE FAST
Selects fast mode.
Manual operation: See "Timing - Power Analysis" on page 257
:SENSe[:POWer]:SWEep:POWer:YSCale:AUTO <Auto>
Activates autoscaling of the Y axis of the diagram.
Parameters:
<Auto> OFF | CEXPanding | FEXPanding | CFLoating | FFLoating
Power sensor measurement subsystems