R&S SMA100B - Page 538

Remote control commands
R&S
®
SMA100B
538User Manual 1178.3834.02 ─ 09
:TRACe<ch>[:POWer]:SWEep:COPY <Copy>
Stores the selected trace data as reference trace.
Setting parameters:
<Copy> REFerence
Example:
TRAC2:SWE:COPY REF
Stores the current trace2 as reference trace'
TRAC1:SWE:FEED REF
Assigns the reference trace to trace 1.
Usage: Setting only
Manual operation: See "Save to Ref - Trace Power Analysis" on page 251
:TRACe<ch>[:POWer]:SWEep:DATA:POINts?
Queries the number of measurement points of the selected trace of the current power
analysis.
Return values:
<Points> integer
Range: 10 to 1000
*RST: 0
Example:
TRAC1:SWE:DATA:POIN?
Response: 624
Measurement trace 1 contains 624 measurement points
Usage: Query only
:TRACe<ch>[:POWer]:SWEep:DATA:XVALues?
Queries the x-axis values - frequency, power or time values - of the selected trace of
the current power analysis.
Return values:
<XValues> string
Example:
SENS:SWE:MODE FREQ
Sets measurement mode frequency versus power.
SENS:SWE:RMOD SING
Selects single measurement.
SENS:SWE:INIT
Starts the measurement.
*OPC?
Waits until measurement is performed.
TRAC1:SWE:DATA:XVAL?
Queries the x-axis values of trace 1.
TRAC1:SWE:DATA:YVAL?
Queries the y-axis values of trace 1
Usage:
Query only
Power sensor measurement subsystems