R&S SMA100B - Page 579

Remote control commands
R&S
®
SMA100B
579User Manual 1178.3834.02 ─ 09
Manual operation: See "State" on page 87
[:SOURce<hw>]:PM<ch>:SOURce <Source>
Selects the modulation source for phase modulation signal.
Suffix:
PM<ch>
.
1|2
Sets the modulation signal channel.
Parameters:
<Source> LF1 | LF2 | NOISe | EXT1 | EXT2 | INTernal | EXTernal
LF1|LF2
Uses an internally generated LF signal.
EXT1|EXT2
Uses an externally supplied LF signal.
NOISe
Uses the internally generated noise signal.
INTernal
Uses the internally generated signal of LF1.
EXTernal
Uses an external LF signal (EXT1).
*RST:
LF1 <PM1>; LF2 <PM2>
Example: See Example "Performing phase modulation" on page 577.
Manual operation: See "Source" on page 87
[:SOURce<hw>]:PM:MODE <Mode>
Selects the mode for the phase modulation.
Parameters:
<Mode> HBANdwidth | HDEViation | LNOise
HBANdwidth
Sets the maximum available bandwidth.
HDEViation
Sets the maximum range for ΦM deviation.
LNOise
Selects a phase modulation mode with phase noise and spuri-
ous characteristics close to CW mode.
*RST: HBANdwidth
Example: See Example "Performing phase modulation" on page 577.
Manual operation: See "Mode" on page 90
SOURce subsystem