R&S SMA100B - Page 578

Remote control commands
R&S
®
SMA100B
578User Manual 1178.3834.02 ─ 09
// Configure the Phase modulation settings with combined LF signal sources
SOURce1:PM1:SOURce LF1
SOURce1:PM1:DEViation 1.5
// Select the modulation signal source for the second path
SOURce1:PM2:SOURce LF2
// Combine the signals of both paths with fixed total deviation depth
SOURce1:PM1:DEViation:MODe TOT
SOURce1:PM1:DEViation:SUM 2
// Query the deviation depth of the modulation signal in the second path
SOURce1:PM2:DEViation?
// Response: 0.5
// Combine the signals of both paths with fixed ratio
SOURce1:PM1:DEViation:MODe RAT
SOURce1:PM1:RATio 80
SOURce1:PM2:DEViation?
// Response: 1.2
// Query the deviation depth of modulation signal in the first path
SOURce1:PM1:DEViation?
// Response: 1.5
SOURce1:FM1:STATe 1
SOURce1:FM2:STATe 1
The following commands are available:
[:SOURce<hw>]:PM<ch>:STATe......................................................................................578
[:SOURce<hw>]:PM<ch>:SOURce.................................................................................. 579
[:SOURce<hw>]:PM:MODE............................................................................................ 579
[:SOURce<hw>]:PM:DEViation:MODE............................................................................. 580
[:SOURce<hw>]:PM:DEViation:SUM................................................................................580
[:SOURce<hw>]:PM:RATio..............................................................................................580
[:SOURce<hw>]:PM:SENSitivity?.................................................................................... 580
[:SOURce]:PM<ch>[:DEViation].......................................................................................581
[:SOURce<hw>]:PM<ch>:STATe <State>
Activates phase modulation.
Activation of phase modulation deactivates frequency modulation.
Suffix:
PM<ch>
.
1|2
Sets the modulation signal channel.
Parameters:
<State> 1 | ON | 0 | OFF
*RST: 0
Example: See Example "Performing phase modulation" on page 577.
SOURce subsystem