R&S SMA100B - Page 594

Remote control commands
R&S
®
SMA100B
594User Manual 1178.3834.02 ─ 09
Example: Configure and generate a ADF signal
:SOURce1:ADF:PRESet
// Configure ADF COM/ID settings.
:SOURce1:ADF:COMid:PERiod 9
:SOURce1:ADF:COMid:FREQuency 1020
:SOURce1:ADF:COMid:DEPTh 11
:SOURce1:ADF:COMid:TSCHema USER
:SOURce1:ADF:COMid:DOT 0.11
:SOURce1:ADF:COMid:DASH 0.29
:SOURce1:ADF:COMid:SYMBol 0.11
:SOURce1:ADF:COMid:LETTer 0.29
:SOURce1:ADF:COMid:STATe 1
:SOURce1:ADF:STATe 1
Example: Configure and generate an ILS glide slope signal
:SOURce1:BB:ILS:PRESet
// Configure ILS localizer general settings.
:SOURce1:ILS:TYPE GS
:SOURce1:ILS:GS:FREQuency:MODE USER
:SOURce1:ILS:GS:FREQuency 334700000
:SOURce1:ILS:GS:FREQuency:MODE ICAO
:SOURce1:ILS:GS:ICAO:CHANnel?
// CH18X
:SOURce1:ILS:GS:FREQuency:SYNChronize 1
:SOURce1:ILS:LOCalizer:ICAO:CHANnel?
// CH18X
:SOURce1:ILS:LOCalizer:FREQuency?
// 108100000
:SOURce1:ILS:GSLope:SOURce?
// INT
// Configure ILS glide slope signal settings.
:SOURce1:ILS:GS:MODE NORM
:SOURce1:ILS:GS:DDM:POLarity P90_150
:SOURce1:ILS:GS:ULOBe:FREQuency 90
:SOURce1:ILS:GS:LLOBe:FREQuency 150
:SOURce1:ILS:GS:PHASe 0
// Configure ILS glide slope amplitude settings.
:SOURce1:ILS:GS:DDM:DIRection UP
:SOURce1:ILS:GS:SDM 80
:SOURce1:ILS:GS:DDM:COUPling FIX
:SOURce1:ILS:GS:DDM:STEP DEC
:SOURce1:ILS:GS:DDM:CURRent 0
:SOURce1:ILS:GS:DDM:DEPTh 0
:SOURce1:ILS:GS:DDM:LOGarithmic 0
:SOURce1:ILS:GS:DDM:PCT 0
SOURce subsystem