R&S SMA100B - Page 599

Remote control commands
R&S
®
SMA100B
599User Manual 1178.3834.02 ─ 09
Example: See Example "Save/Recall a configuration" on page 593.
Usage: Setting only
<subsystem>:SETTing:STORe
[:SOURce<hw>]:ADF:SETTing:STORe <Filename>
[:SOURce<hw>]:ILS:SETTing:STORe <Filename>
[:SOURce<hw>]:VOR:SETTing:STORe <Filename>
Saves the current settings into the selected file; the file extension
(*.adf/*.ils/*.vor) is assigned automatically.
Parameters:
<Filename> "<filename>"
Filename or complete file path
Example: See Example "Save/Recall a configuration" on page 593.
Usage: Setting only
<subsystem>:STATe
[:SOURce<hw>]:ADF:STATe <State>
[:SOURce<hw>]:ILS:STATe <State>
[:SOURce<hw>]:VOR:STATe <State>
Activates/deactivates the VOR modulation.
Parameters:
<State> 1 | ON | 0 | OFF
*RST: 0
Example: See Example "Save/Recall a configuration" on page 593.
<subsystem>:FREQuency:SYNChronize:STATe
[:SOURce<hw>]:ILS[:GS|GSLope]:FREQuency:SYNChronize[:STATe] <Mode>
[:SOURce<hw>]:ILS:LOCalizer:FREQuency:SYNChronize[:STATe] <Mode>
Activates synchronization of the ILS localizer ICAO channel with the ILS glide slope
ICAO channel.
The ILS glide slope/localizer frequency of the ICAO channel (Table 6-2) is set automat-
ically.
Parameters:
<Mode> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Configure and generate an ILS localizer signal"
on page 595.
SOURce subsystem