R&S SMA100B - Page 631

Remote control commands
R&S
®
SMA100B
631User Manual 1178.3834.02 ─ 09
Manual operation: See "Carrier Frequency" on page 136
[:SOURce<hw>]:VOR:FREQuency:MODE <Mode>
Sets the mode for the carrier frequency of the signal.
Parameters:
<Mode> DECimal | ICAO
DECimal
Activates user-defined variation of the carrier frequency.
ICAO
Activates variation in predefined steps according to standard
VOR transmitting frequencies (see Table 6-1).
*RST: DECimal
Example: See Example "Configure and generate a VOR signal"
on page 596.
Manual operation: See "Carrier Frequency Mode" on page 135
[:SOURce<hw>]:VOR:ICAO:CHANnel <Channel>
Sets the ICAO channel and the corresponding transmitting frequency.
If avionic standard modulation is activated and you change the "RF Frequency", the
frequency value of the closest ICAO channel is applied automatically. The "ICAO
Channel" is also updated.
The carrier frequency is set automatically to the value of the ICAO channel. For an
overview of the VOR ICAO channel frequencies, see Table 6-1.
SOURce subsystem