R&S SMA100B - Page 630

Remote control commands
R&S
®
SMA100B
630User Manual 1178.3834.02 ─ 09
Example: See Example "Configure and generate a VOR signal"
on page 596.
Manual operation: See "Symbol Space" on page 142
[:SOURce<hw>]:VOR:COMid:TSCHema <Tschema>
Sets the time schema of the Morse code for the COM/ID signal.
Parameters:
<Tschema> STD | USER
STD
Activates the standard time schema of the Morse code.
The set dot length determines the dash length, which is 3
times the dot length.
USER
Activates the user-defined time schema of the Morse code.
Dot and dash length, as well as symbol and letter space
can be set separately.
*RST: STD
Example: See Example "Configure and generate a VOR signal"
on page 596.
Manual operation: See "Time Schema" on page 141
[:SOURce<hw>]:VOR:COMid[:STATe] <State>
Enables/disables the COM/ID signal.
Parameters:
<State> 1 | ON | 0 | OFF
*RST: 0
Example: See Example "Configure and generate a VOR signal"
on page 596.
Manual operation: See "COM/ID State" on page 140
[:SOURce<hw>]:VOR:FREQuency <CarrierFreq>
Sets the carrier frequency of the signal.
Parameters:
<CarrierFreq> float
Range: 100E3 to 6E9
Increment: 0.01
*RST: 108E6
Example: See Example "Configure and generate a VOR signal"
on page 596.
SOURce subsystem