R&S SMA100B - Page 70

RF signal configuration
R&S
®
SMA100B
70User Manual 1178.3834.02 ─ 09
Settings:
Signal............................................................................................................................ 70
Connector......................................................................................................................71
Show Connector............................................................................................................71
Signal
Displays the signal that is assigned to the connector.
Selecting a signal accesses the settings dialog for configuring the signal, or setting sig-
nal characteristics directly.
For additional information on the connectors, see:
●
Chapter 3.2.2.1, "Connectors", on page 44
●
"Signal output" on page 82 for the assignment of the input and output connectors
used for analog modulation signals.
"Instr. Trigger"
Input of an external trigger signal for sweep and list modes, see
Chapter 7.1, "Signal generation and triggering in the sweep and list
modes", on page 173.
"External
Mod..."
Input of an external modulation signal, see "Signal sources"
on page 81.
"LF Output"
Output of the internal LF gennerator signal, Chapter 5.4.8, "LF signal
output settings", on page 120.
"Ref. Freq.
Input"
Input of an external reference signal, see Chapter 9.2, "Reference
frequency settings", on page 294 .
RF connector settings