R&S SMA100B - Page 703

Remote control commands
R&S
®
SMA100B
703User Manual 1178.3834.02 ─ 09
Parameters:
<Logarithmic> float
The unit dB is mandatory.
Range: 0.01 to 139 dB
Increment: 0.01
*RST: 1
Default unit: dB
Example: See Example "Setup an RF frequency or power sweep"
on page 697.
Manual operation: See "Step" on page 197
[:SOURce<hw>]:SWEep[:FREQuency]:ANALog:SWPoints?
Queries blank points during the RF frequency sweep in ramp sweep mode.
At certain switchover frequency points, the R&S SMA100B shortly blanks the RF signal
to adjust the settings accordingly.
This query returns all blanked frequency points within the entire frequency range,
regardless of the set frequency sweep range.
Example:
See Example "Setup an RF frequency or power sweep"
on page 697.
Usage: Query only
[:SOURce<hw>]:SWEep[:FREQuency]:DWELl <Dwell>
Sets the dwell time for a frequency sweep step.
Parameters:
<Dwell> float
Range: 0.001 to 100
Increment: 100E-6
*RST: 0.01
Example: See Example "Setup an RF frequency or power sweep"
on page 697.
Manual operation: See "Dwell Time" on page 192
[:SOURce<hw>]:SWEep[:FREQuency]:MODE <Mode>
Sets the cycle mode for the frequency sweep.
Parameters:
<Mode> AUTO | MANual | STEP
AUTO
Each trigger event triggers exactly one complete sweep.
SOURce subsystem