R&S SMA100B - Page 765

Maintenance, storage and disposal
R&S
®
SMA100B
765User Manual 1178.3834.02 ─ 09
5. Confirm with "Ok".
If the terminating resistor is missing, or you have not terminated the RF output with
50 Ω, a second warning message appears.
The adjustment process aborts.
If the internal adjustment has started, do not interrupt the process.
A progress indicator shows the status of the adjustment process. The extent of the
adjustments depends on the installed options.
If any error occurs, the process aborts, and an error message appears in the "Info"
line.
If there is an error:
● Select "Info".
Observe the error message.
● Continue the process.
See "Continuing the adjustment process if error appears" on page 765.
Continuing the adjustment process if error appears
Per default, if any error occurs during the adjustment process, the process aborts. An
error message appears in the "Info" line.
If you prefer to finish the adjustments also if there is an error, proceed as follows:
1. Select "System Config > Setup > Security > Protection" an unlock the protection
level 1.
See "Protection Level/Password" on page 362.
2. Select "System Config > Setup > Internal Adjustment > Configuration > Continue
Adjustment on Error > On".
3. Proceed as described in "Running internal adjustments" on page 764.
Performing maintenance tasks