Rohde & Schwarz R&S FSL3 - Page 1403

Remote Commands of the 1xEV-DO BTS Analyzer Option (K84) R&S FSL
1300.2519.12 6.644 E-11
CONFigure:CDPower Subsystem (EVDO, K84)
This subsystem contains the commands for measurement selection and configuration of the 1XEV-DO
BTS Analyzer option.
Further setting commands for the spectrum emission mask measurement are in the
"CALCulate:LIMit:ESPectrum Subsystem (EVDO, K84)" on page 6.636.
Commands of the CONFigure:CDPower Subsystem
– CONFigure:CDPower[:BTS]:CTABle[:STATe]
– CONFigure:CDPower[:BTS]:CTABle:CATalog?
– CONFigure:CDPower[:BTS]:CTABle:COMMent
– CONFigure:CDPower[:BTS]:CTABle:COPY
– CONFigure:CDPower[:BTS]:CTABle:DATA
– CONFigure:CDPower[:BTS]:CTABle:DELete
– CONFigure:CDPower[:BTS]:CTABle:NAME
– CONFigure:CDPower[:BTS]:CTABle:RESTore
– CONFigure:CDPower[:BTS]:CTABle:SELect
– CONFigure:CDPower[:BTS]:BCLass
– CONFigure:CDPower[:BTS]:MCARier[:STATe]
– CONFigure:CDPower[:BTS]:MEASurement
– CONFigure:CDPower[:BTS]:PVTime:BURSt
– CONFigure:CDPower[:BTS]:PVTime:FREStart
– CONFigure:CDPower[:BTS]:PVTime:LIST[:STATe]
– CONFigure:CDPower[:BTS]:PVTime:LIST:RESult?
– CONFigure:CDPower[:BTS]:REVision
– CONFigure:CDPower[:BTS]:RFSLot
CONFigure:CDPower[:BTS]:CTABle[:STATe]
This command activates or deactivates the ‘RECENT’ channel table. To select another channel
table, use the CONFigure:CDPower[:BTS]:CTABle:SELect command.
Parameter
ON | OFF
Example
CONF:CDP:CTAB ON
Activates predefined channel table.
Characteristics
RST value: OFF
SCPI: device-specific
Mode
EVDO