Santana PS-10 User Manual

CLUTCH 7C-9
CLUTCH LIQUID REPLACEMENT
1) Place a flexible, transparent tube (1) with one end (2)
attached to the bleeder and the other in a glass measuring
cylinder.
2) Open the bleeder and pump until a great deal of air comes
out of the bleeder.
3) Stop pumping and fill tank (5) to maximum (Max) using new
recommended fluid.
4) Start pedalling again until the tank is empty.
5) Check that fluid in the cylinder is approximately double that
of the circuit total. This guarantees that the old fluid has
been successfully flushed out.
NOTE:
Never use the old fluid - not even in bleeding
operations.
6) Carry out the final bleeding (see 7C-5) and adjust the fluid
level to maximum.
1
4
2
5
3

Santana PS-10 Specifications

General

Brand	Santana
Model	PS-10
Category	Automobile
Language	English