Santana PS-10 User Manual

1A-8 HEATER AND VENTILATION
HEATER BLOWER MOTOR SWITCH
Removal
1) Remove heating system control levers (see 1A-9).
2) Remove heater blower motor switch nuts.
3) Remove switch, disconnect connector and check continuity
from terminal to terminal.
Instalation
1) Install a new switch, if necessary, and the other components
reversing removal procedure, noting to tighten to specified
torque.
CONTROL CABLE ADJUSTMENT
To adjust any control cable:
1) Put the control lever at the OFF position.
2) Place the corresponding acting element at the OFF position
and fix the cable.
1

Santana PS-10 Specifications

General

Brand	Santana
Model	PS-10
Category	Automobile
Language	English