Santana PS-10 User Manual

7C-8 CLUTCH
THRUST BLOCK REPLACEMENT
Removal
1) Remove gearbox assembly from engine (see 7A-8).
2) Remove plastic clip (1) and take out thrust block (2).
NOTE:
The coupling and bearing form one single assembly
and therefore should be replaced if any anomalies are
found.
Instalation
1) Install in reverse order to dismantling, noting the indicated
observation and the specified torque.
• Lubricate the turret in which the thrust block moves.
2
1

Santana PS-10 Specifications

General

Brand	Santana
Model	PS-10
Category	Automobile
Language	English