7E- 2 DIFFERENTIALS
GENERAL DESCRIPTION
The differentials use conical pinions and gears of the hypoid type being installed in the front and rear axle screwed to the
sump of each axle.
Dimensionally, the front differential and the rear are different , their components therefore not being exchangeable,
although the gear ratio (engaging pinion and crown ) is the same for both. As a standard, the ratio 43:11 is used
Differential ensembles are fundamental, as the traction force is concentrated in them. Consequently, authorised main
dealer pieces should be used. Tightening torques should be applied as specified, repair data and specifications followed
and recommended products used only either in repairs or in every day running use. The procedures applied when repairing
the front differential as explained herein are also valid for the rear differential, unless when specifically stated.
NOTA:
El procedimiento a seguir para la reparación del diferencial delantero explicado mas adelante, es aplicable
al diferencial trasero, excepto las diferencias que se describen para es último.
To Next Page
Loading...
Need help?
General