Shimadzu GC-2010 Plus - Page 159

12 Injection Port
12.5 Split/Splitless Injection System
139
GC-2010 Plus
12.5.9.1 Screen description
Select [Advanced] (PF menu) from the [FLOW] key main screen when not in “DIRECT”
mode to open the advanced screen shown in Fig. 12.5.14.
12.5.9.2 Parameter list
Q High Pressure Injection
HIGH PRESS INJECTION MODE
Select One of the following three modes.
Off : Disables high pressure injection.
On : Sets the column inlet pressure for high pressure injection immediately.
Auto : Immediately sets the column inlet pressure for high pressure injection. When analysis
is finished and the GC returns to the ready state, the column inlet pressure
automatically increases.
Fig. 12.5.14 Setup screen for high pressure injection and splitter fix mode
HIGH PRESS INJECTION MODE = On HIGH PRESS INJECTION MODE = Auto