Shimadzu GC-2010 Plus - Page 348

20 Appendix
20.1 Key Function List
328
GC-2010 Plus
Use time program when the parameter is changed during analysis.
Input the event No. and run at once.
Use to set tha date and the time.
Use to set the maximum temperature of each heater ports.
Use to set the parameter related to transmission.
3. Time Program
4. Pre-Pun
5. Direct
Operation
6. GC
Configuration
1. Date/Time
Setting
2. Max.
Temperature
3. Transmission
Parameter
4. Ready Check
5. Signal Setting
6. Port Name
Customization
7. Link Device
Code
8. Temperature
Offset
9. Other
Configuration
7. Service/
Maintenance
8. Stop Watch
9. Lock
Use Pre-Run program when the parameter is changed before
analysis is started.
Use to set the items, which should be satisfied to light the STATUS
indicator lamp and make the system ready.
Use to set the signals, which can be output from the gas
chromatograph.
Use to change heater ports name, carrier ports name, AUX APC
name, relay name displayed on the screen.
The key operations of the gas chromatograph can be automated by
setting the weekly or daily schedule using the timer.
1. Time
Scheduler
Use to continuously and automatically perform analysis with auto
injector.
2. Batch
Use to set the link device code when using it.
Use to set the temperature offset for each heater port.
Use to set the language and the beep etc.
Use to set the flow controller or initialize etc.
The stop watch can be used.
The key locking and the parameter locking can be used.
FUNC