Introduction to Parameters
Parameters
1-11
© Siemens AG 2007 All Rights Reserved
SINAMICS G120 Control Units CU240S, Edition 05/2007
Can be changed
Inverter state in which the parameter is changeable. Three states are possible:
This indicates when the parameter can be changed. One, two or all three states
may be specified. If all three states are specified, this means that it is possible to
change this parameter setting in all three inverter states.
Unit
Indicates the unit of measure applicable to the parameter values.
Min
Indicates the minimum value to which the parameter can be set.
Max
Indicates the maximum value to which the parameter can be set.
Factory setting
Indicates the default value, i.e. the value which applies if the user does not specify
a particular value for the parameter.
Description
Explanation of the function of a parameter.
Values
Lists the possible values of a parameter.
Recommendation
Information about recommended settings.
Index
The name and meaning of each individual index is specified for indexed para-
meters, except indexed parameters which belong to a data set (see Data set).
• Commissioning C
• Run U
• Ready to runt T
To Next Page
Loading...
Need help?
General
