Message
class
PN
1)
(hex)
Explanation of the message class according to PROFIdrive -
cause and remedy.
18 9011 Error in the parameterization/configuration/commissioning sequence
An error has been identified in the parameterization or in a commissioning
procedure, or the parameterization does not match the actual device configu‐
ration.
● Determine the precise cause of the fault using the commissioning tool.
● Adapt the parameterization or device configuration.
19 9012 General drive fault
Group fault.
● Determine the precise cause of the fault using the commissioning tool.
1)
"Channel Error Type" of the PROFINET channel diagnostics. When channel diagnostics is activated,
then the fault texts are indicated in the PLC.
Diagnostics
7.2 Message classes in accordance with PROFIdrive
SINAMICS S210 servo drive system
170 Operating Instructions, 12/2017, A5E41702836B AA
To Next Page
Loading...
