SMC Networks TigerSwitch SMC6128PL2

F LASH /F ILE C OMMANDS
4-93
• If the file type is used for system startup, then this file cannot be
deleted.
• “Factory_Default_Config.cfg” cannot be deleted.
• A colon (:) is required after the specified unit number.
Example
This example shows how to delete the test2.cfg configuration file from
flash memory for unit 1.
Related Commands
dir (4-93)
delete public-key (4-52)
dir
This command displays a list of files in flash memory.
Syntax
dir [unit:] {{boot-rom: | config: | opcode:} [:filename]}
The type of file or image to display includes:
- boot-rom - Boot ROM (or diagnostic) image file.
- config - Switch configuration file.
- opcode - Run-time operation code image file.
- filename - Name of the configuration file or code image.
- unit - Stack unit. (Always unit 1)
Default Setting
None
Command Mode
Privileged Exec
Command Usage
• If you enter the command dir without any parameters, the system
displays all files.
• A colon (:) is required after the specified unit number.
Console#delete 1:test2.cfg
Console#