Commands Listed in Alphabetical Order
Syntax
BUSY?
Related Commands
*OPC, *WAI
Returns
<NR1>=0 means that the instrument is not busy processing a command whose
execution time is extensive.
<NR1>=1 means that the instrument is busy processing a command Commands
that Generate an OPC Message(See Table 2-18.).
Examples
BUSY? might return :BUSY 1, indicating that the instrument is currently busy.
*CAL? (Query Only)
This query-only command starts signal path compensation and returns the status
upon completion.
Group
Calibration
Syntax
*CAL?
Related Commands
CALibrate:RESults:SPC?
Returns
0 indicates SPC passed.
-1 indicates SPC failed.
3 indicates the instrument is still in the warm up phase and SPC was not run.
Examples
*CAL? starts the internal signal path calibration and returns the status upon
completion.
CALibrate? (Query Only)
This query returns the status of instrument calibration, including internal signal
path calibration, factory c alibration, and probe calibration.
Group
Calibration
2-102 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
